This is the Sport Model - Long Handle - The Sport model is designed specifically for fiberglass boats or most aluminum boats that have a bow eye that is directly mounted into the boat without a mounting plate. It will come with a 2 piece handle. The long handle is an automatic reset handle.Stainless Steel NON Corrosive - Upgraded Stoltz Polyurethane Protector - Comes with a small Roller on the front to prevent the bow tip from catching when launching - Built in poly washer on the mounting plate for a smooth pivoting rotation - Clamp travels past the polyurethane to prevent steel on steel wear to your bow eye when latching and traveling - Low profile design to prevent boat and trailer displacement after installInstallation of the Boat2Trailer automatic boat latch is very simple. This boat latch is designed to be a bow roller replacement, therefore it is a one bolt installation. You can simply remove your bow roller from your boat trailer and install our Ramp N Clamp Boat2Trailer automatic boat latch in its place. The installation takes roughly 10 minutes. Be sure to use roughly 18 - 22 ft lbs pressure on the install bolt (snug). This way your latch can still pivot when needed at steeper landings.MADE IN USA - Our Boat2Trailer Latch by Ramp N Clamp is manufactured here in the U.S.A. The automatic boat latch by Ramp N Clamp has been collaboratively engineered at Skeeter, Ranger and Mastercraft boats and in production in the United States since 2012.What it does - The automatic boat latch allows you to load a boat by your self in seconds. You simply drive your boat up the trailer. Once the eye of the boat comes in contact with the clamp device, it will lock onto the eye and lock your boat to the trailer. You then exit the boat and pull to the dry waters edge to hookup your safety chain and strap for travel. It's that easy. Boat2Trailer dot com has many helpful videos as well.